The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 06-29-2012, 04:22 AM   #1
DBear
Registered User
 
DBear's Avatar
 
Join Date: Nov 2008
Location: Rowlett, TX
Posts: 867
Can someone explain this...

Took the 71 4x4 Burb out for a short spin, which was from the exhaust shop to my house, and while driving it down the road, the burb seemed to "walk" or something like it quite a bit. To explain it, when I say walk, I mean it wanted to jerk left or right depending on the condition of the pavement. Can someone tell me what is going on, and if so, what probably will correct it? Thanks in advance
DBear is offline   Reply With Quote
Old 06-29-2012, 05:55 AM   #2
OhioDan
Registered User
 
OhioDan's Avatar
 
Join Date: Apr 2002
Location: New Carlisle, Ohio,USA
Posts: 1,404
Question Re: Can someone explain this...

Sounds like ya might need a frontend alignment? Sounds like it's trying to climb the rise in the center of the lane you're in? Have you done any work to the front end? Or, something is worn to the point that it's in very bad if not dangerous condition. I'd recommend you take it to an alignment shop to have it checked? Just my $.02 .
__________________

LIFE AIN'T EASY WHEN YER FAT AND GREASY!
GMC= Got More Class!
1970 GMC LWB, Fleetside, 350/4spd, Flowmaster "40's", 2002 GMC 16" Rallies, cowl hood,and added a bunch of options that weren't there when I started.
OhioDan is offline   Reply With Quote
Old 06-29-2012, 08:46 AM   #3
Stocker
20' Daredevil (Ret)
 
Stocker's Avatar
 
Join Date: May 2003
Location: Jefferson State
Posts: 13,722
Re: Can someone explain this...

Could be any number of worn steering components..... also, wider tires and wheels with more negative offset will cause tramlining (following pavement irregularities).
__________________
- Mike -

1972 K20 LWB 350/350/205

RIP El Jay
Stocker is offline   Reply With Quote
Old 06-29-2012, 08:56 AM   #4
too much stuff
Roadtrip!
 
too much stuff's Avatar
 
Join Date: Feb 2003
Location: Grand Rapids MN
Posts: 13,786
Re: Can someone explain this...

First thing to check is all of your leaf spring plates and make sure they are tight. I have seen this more than once if they are even a little bit loose things will shift some. Are you running bias-ply tires? Those will also follow any crack in the road.
__________________
67 gmc custom lwb dakota truck. Sold...And bought back
69 swb 4x4 project (in progress)
70 c-10 lwb texas truck
70 4x4/BB/bkts/posi/tach(retired)
70 swb (wifes)
70 jimmy camper
71 K-5 factory 2wd
71 cheyenne 4x4/tach/posi/ plow rig
71 Cheyenne20 BB, buckets, tach, tilt, 4 speed
72 jimmy CST wyoming rig
72 jimmy Colorado rig
72 lifted texas 4x4 3/4 ton burb
65 fury conv. 383/auto
65 chrysler 300 "L" 413 auto
too much stuff is offline   Reply With Quote
Old 06-29-2012, 08:57 AM   #5
dracula4999
Registered User
 
dracula4999's Avatar
 
Join Date: Mar 2010
Location: Shawnee, OK
Posts: 63
Re: Can someone explain this...

With wider tires a vehicle will walk. It will try to follow grooves, walk a little if you hit a bump just right. If your tires are wide enough that they dont drop in the groves then its not as bad. Best thing to do is get a good steering stabilizer shock set up, make sure all your front end parts are good, and you have a good alignment. You will still have some road walk now and then, but wont be as bad. Of course this is all assuming you have wide tires on it.
__________________
71 GMC long bed
70 Chevy short step
71 Chevy K10 long bed
dracula4999 is offline   Reply With Quote
Old 06-29-2012, 10:04 AM   #6
CC69Rat
Registered User
 
CC69Rat's Avatar
 
Join Date: Jan 2011
Location: Chattanooga TN
Posts: 6,212
Re: Can someone explain this...

You can also lay under the truck and check the toe. (This will get you close, and tell you if an alignment would help )

I usually take a tape measure (and a buddy) to hold the tape on the center line of the front tires and get the measurement in front of the tire (up closer to the front bumper) then behind the front tire ( under the door where it meets the front fender)

This will tell you are the front tires running 'turned in' or 'turned out' It sounds to me like it's toe'd out. In this example, the measurement from center line of the tire in front will be slightly more than the center / center behind the tire.

Pic for example - This will also cause the infamous 'Death Wobble' on 4x4s and is very common after lifting. I used to mess around with Jeeps quite a bit. Steering stabilizer will help a bunch too if you have large tires on it
Attached Images
 
__________________
Chad

1967 C10 SWB - Project Savannah - 6.0/4L80 *Currently underway*
1968 C10 SWB - TOTY 2018, 50th Anniversary Tribute Project * Sold * Pride and Joy
1986 Silverado Short Fleet - Scarlet *Sold*
1985 Silverado Short Fleet *Sold*
2022 Jeep Gladiator Mojave
2001 Jeep Cherokee XJ 4x4 - Lifted, Built
1992 Jeep Cherokee XJ 4x4 - Lifted
2013 Honda Accord EX-L v6 Coupe 6spd (wife's ride)
CC69Rat is offline   Reply With Quote
Old 06-29-2012, 01:06 PM   #7
MJN
Registered User
 
MJN's Avatar
 
Join Date: Feb 2000
Location: Maquoketa, Ia/ Orr, Mn
Posts: 3,051
Re: Can someone explain this...

You should also check the condition of the front axle shaft u-joints. If two or more of the caps are froze up just off center it will make the front end jerk to the left or right since the axle shafts are no longer in line with each other. This happened on my '72 Blazer and it took me forever to figure out what the cause of the sudden wandering was.
__________________
'51 South Bend Model "9A"
'56 Chevy 3600 NAPCO
'74 Chevy Cheyenne Super K20-restored on 37's
'72 GMC Sierra Custom K2500- in progress
'08 GMC Envoy Denali
'12 GMC Sierra 2500HD Denali
'17 GMC Yukon XL
VCCA member #58596
http://www.nohrco.com
MJN is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:28 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com