|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
12-23-2012, 12:46 AM
|
#1 |
|
Registered User
Join Date: Nov 2012
Location: DFW, TX
Posts: 298
|
lift spindles with 73-87 ball joints on 71 control arms?
Hi guys
Im looking at lifting my 71 C10 up a couple of inches. I see that some companies make the 88-98 lifted spindles. I need new ball joints anyway, so i was wondering if the 73-87 or 88-98 ball joints could be mounted to my 71 upper/lower control arms and then bolt the 88-98 lift spindles to the new ball joints??? thanks guys |
|
|
|
12-23-2012, 03:38 AM
|
#2 |
|
Registered User
 Join Date: Feb 2010
Location: The Dalles Oregon
Posts: 191
|
Re: lift spindles with 73-87 ball joints on 71 control arms?
I am subscribed I might be picking up a 72 and wanting to do this also
Posted via Mobile Device
__________________
1966 C-10 long wide- currently with 2 3/4 sectioned crossmember, 3 inch cupped a arms with 2700 bags, 67 master cylinder, in the middle of a v8 swap, soon custom rear wishbone set up and bags 1942 chevy/divco ambulance 1937 chevy truck |
|
|
|
|
12-23-2012, 10:12 AM
|
#3 |
|
Registered User
Join Date: Nov 2012
Location: DFW, TX
Posts: 298
|
Re: lift spindles with 73-87 ball joints on 71 control arms?
Ive read that id need 3/4 lower control arms, but then ive read where i just need the newer ball joints
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
