![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Apr 2010
Location: Boise, ID
Posts: 1,280
|
LMC Seat Belts barely poke through the bench seat
I think I have the thicker foam seat but is this normal or are there extensions. It's a bit of a pain. Thanks.
Also, if somebody has a pic of the way the receiving belt with the female end bolts to the floor it would help. I just did mine so it would have the most reach, facing up. |
![]() |
![]() |
![]() |
#2 | |
Maintenance Man
Join Date: May 2002
Location: Phoenix, AZ US
Posts: 213
|
Re: LMC Seat Belts barely poke through the bench seat
Quote:
No single fastener has ever been the same size/fitment as the factory fastener, no sheetmetal piece has ever fit even close to correctly. I take that back. The stock height coil springs for the 71 LWB C10 fit fine, as did the replacement rubber sway bar bushings, and the I/O tie rods. Everything else has been a crap shoot. |
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Apr 2010
Location: Boise, ID
Posts: 1,280
|
Re: LMC Seat Belts barely poke through the bench seat
Yeah, that has been the case for me as well. Bolts were not the right thread, had to go buy them as well.
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Jun 2012
Posts: 1,089
|
Re: LMC Seat Belts barely poke through the bench seat
Guess I have been lucky with LMC have not had any problems with there products everything has fit fine.
Posted via Mobile Device |
![]() |
![]() |
![]() |
Bookmarks |
|
|