|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
02-26-2013, 10:35 PM
|
#1 |
|
Registered User
Join Date: Feb 2013
Location: Gilbert, AZ
Posts: 46
|
Help with my 2004r 200r4
<UIMenuController: 0x1fc39b60><UIMenuController: 0x1fc39b60><UIMenuController: 0x1fc39b60>I'm doing my 2004r tranny swap and I ran into a situation. I'm not a transmission guy but I'm mechanical enough to rebuild an engine. how do I put the linkage back in the transition? where do I get the parts? I hope this picture loads to help
|
|
|
|
02-26-2013, 11:47 PM
|
#2 |
|
Registered User
Join Date: Feb 2013
Location: Gilbert, AZ
Posts: 46
|
Re: Help with my 2004r 200r4
Here is the picture.
Posted via Mobile Device |
|
|
|
|
02-27-2013, 10:31 PM
|
#3 |
|
Registered User
 
Join Date: May 2011
Location: Long Island NY
Posts: 787
|
Re: Help with my 2004r 200r4
where did it go? Did it fall into the pan? Have you had that pan of?
Go to www.wittrans.com they have a good blow out parts diagram for that trans. |
|
|
|
|
02-27-2013, 11:45 PM
|
#4 | |
|
Registered User
Join Date: Feb 2009
Location: southeasternfoothillsofusa
Posts: 1,557
|
Re: Help with my 2004r 200r4
Quote:
HTH, sam |
|
|
|
|
|
02-27-2013, 11:45 PM
|
#5 |
|
Registered User
Join Date: Feb 2013
Location: Gilbert, AZ
Posts: 46
|
it's broken off inside. it came out of a running impala that was wrecked. I just put it in my truck today. I'm guessing that when he removed the trans he didn't put a lock wrench on the shift shaft. I've never replaced one on a 200-4r. I've help with one on a th350. is it the same procedure?
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
