NJ Cleaning out the garage - 1964 Chevy

[wayno]

I'm replacing the front and rear suspension with a Porterbuilt front and rear so I have the following to part with along with some other various engine parts: I'm not looking to ship any of this as I don't have the time to research the shipping costs for each item and a lot of this is just plain too big to mess with.


SUSPENSION PARTS ($400)
- Rear Trailing Arms
- Trailing Arm Cross Member
- Rear Shock Member
- Rear Springs (STOCK)
- Entire Front Cross Member - including upper and lower control arms

327 CHEVY ENGINE ($1000)
- Not original to the truck - out of a 62 corvette I'm told (still has upper front motor mount for a corvette - chrome - told worth $100-$200)
- HEI Distributor
- Edelbrock Carb, Water Pump, Intake
- Billet Parts - water pump nose cone
- Holley Manual Fuel Pump

64 4 speed transmission (Granny Low) - $300
- Not including the Bell

In Cab Gas Tank ($150)
- including functioning sending unit
- No leaks (in fact still half a tank of gas that will need to come out)
- Might still have the straps that held it in as well

-Driver's side rear stepside fender ($250)
- This is with the cutout for the spare
- Not willing to part with this until it's replacement arrives (being shipped greyhound - awaiting it's arrival now) -lowering truck so replacing with one with no cutout.

Will try and get some pictures up later today but wanted to get this out there.

[wayno]

A few pictures as promised

[wayno]

And the tank.

[Goinlow64]

Have any side mirrors you are selling? Thanks!

[wayno]

No mirrors as of now - some debate going on right now (in my own head) on whether to shave the door handles or not - but if I end up going down that road there might be some mirrors to be had - I'll keep you posted.

[wayno]

ttt - make me an offer.

[ScottH]

Any idea of condition of engine? how long has it been out of truck, could u post casting # of block and heads?

Thanks
Scott

[wayno]

Scott I don't know a whole lot about the engine itself - it's been out of the truck a couple of months - I pulled it as part of a frame off restoration I'm doing on the truck- I can tell you it was running when it came out and was able to drive it though the development and it wasn't blowing smoke or anything.

a couple of pictures here... the numbers on the back of the block appear to be 3903352

on the end 3782461 A295

hope this helps.

[ScottH]

Thanks for the pics & info. Sorry to b a pia but could u post the info on the block pad just in front of the passengers side head? Also the head casting # (pull valve cover & u should c them).

No hurry, thanks
Posted via Mobile Device

[wayno]

Hopefully these help...

[wayno]

The engine goes to ScottH and the step-side fender became available over the weekend if anyone is interested.

[rsmarr1982]

Originally Posted by wayno

The engine goes to ScottH and the step-side fender became available over the weekend if anyone is interested.

do you already have a driver side fender without the cut out? if not interested in a trade?

[wayno]

I do - was waiting for it to show up - was shipped via greyhound from the west coast - having not shipped anything in that manner I wasn't convinced I would ever see it lol.