Looking for some fender ID help - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Thealien** · 10-06-2013, 07:22 PM

I have an OEM new never installed fender (basically NOS but its been primed) I had purchased to install on my 1972 GMC Jimmy. I have it for sale HERE ON THE FOR SALE SECTION A member or two questioned whether it was OEM or repop. I Know what it is and another member basically showed the differences in OEM and repop. Some members seem to think if the fender does not have the little triangles at the top seam they are not OEM. I know we have some very knowledgeable members here who can help pointing out the differences and maybe it will help others out in the future when looking to tell the difference.

Thanks in advance
Mark!

**special-K** · 10-06-2013, 09:33 PM

It looks to have the telltale triangle bumps of OEM at the upper front inside edge. Could you get a closer picture?

**Thealien** · 10-06-2013, 09:42 PM

Actually it does not have the triangle humps, that is where the confusion seems to have started. There seems to be lots without them.

10-06-2013, 07:22 PM	#1
Thealien Senior Member Join Date: Jun 2007 Location: Pine Ridge Florida Posts: 4,135	Looking for some fender ID help I have an OEM new never installed fender (basically NOS but its been primed) I had purchased to install on my 1972 GMC Jimmy. I have it for sale HERE ON THE FOR SALE SECTION A member or two questioned whether it was OEM or repop. I Know what it is and another member basically showed the differences in OEM and repop. Some members seem to think if the fender does not have the little triangles at the top seam they are not OEM. I know we have some very knowledgeable members here who can help pointing out the differences and maybe it will help others out in the future when looking to tell the difference. Thanks in advance Mark! __________________ Click on my Not really a build thread, yet NOT SO RUST FREE RUST FREE BLAZER LS ENGINE SWAP INFORMATION THREAD BOLT RESTORATIONS 4l60 to an NP205

10-06-2013, 09:33 PM	#2
special-K Special Order Join Date: Nov 2004 Location: Mt Airy, MD Posts: 85,851	Re: Looking for some fender ID help It looks to have the telltale triangle bumps of OEM at the upper front inside edge. Could you get a closer picture? __________________ "BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed" GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project) GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling) Tim "Don't call me a redneck. I'm a rough cut country gentleman" R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~

10-06-2013, 09:42 PM	#3
Thealien Senior Member Join Date: Jun 2007 Location: Pine Ridge Florida Posts: 4,135	Re: Looking for some fender ID help Actually it does not have the triangle humps, that is where the confusion seems to have started. There seems to be lots without them. __________________ Click on my Not really a build thread, yet NOT SO RUST FREE RUST FREE BLAZER LS ENGINE SWAP INFORMATION THREAD BOLT RESTORATIONS 4l60 to an NP205



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.