OR WTB powerglide linkage

[LT1 Burb]

I am looking for the linkage that goes from the trans to the block, measures 11 5/8 ", mine grew legs. I can make it easy enough with heim joints but original is preferred, thx.

[southern parts]

check with board member uncle. I think he had some 3 or 4 weeks ago.

I have a set too, but it`s from a 66 impala.

[60-66]

Hopefully this will broaden your search, I looked up the GM part number and from the trans linkage to the bracket assembly its part number 3830310 which the book says 1965-1971 truck with PG, then looked up that number under passenger car in a 69 parts book and it says its the same number for 1964-1969 Nova Chevelle and Camaro with 8 Cyl PG and 1965-1969 Impala. Heres the pages from the parts book group 4.050 .

[60-66]

[LT1 Burb]

Thanks for the info, that definitely makes the search easier.

[sickboy_1456]

I'm pretty sure I have the entire original linkage set from my old powerglide. I'll take a look and let you know.

[LT1 Burb]

Originally Posted by sickboy_1456

I'm pretty sure I have the entire original linkage set from my old powerglide. I'll take a look and let you know.

Sounds great, thanks

[contagious102]

Should have one also ,will look tomorrow and let you know.

[MikeN]

If sickboy and contagious each have a powerglide shift linkage setup available, I would be interested in getting in line behind the OP for one of the linkage sets.

[contagious102]

This is what I have in shop. 30.00 plus shipping?

[LT1 Burb]

I am confused as to what the linkage on the left is, the bracket is the correct one for the frame to shifter linkage on trans, the rest ??

[contagious102]

Have to look again ,that may be for the carb on the in line six.!! lol

[60-66]

Originally Posted by contagious102

Have to look again ,that may be for the carb on the in line six.!! lol

If LT1burb is not interested in that 6 cylinder linkage I would buy it from you. Im building a 6 cylinder truck that was missing several of those pieces .

[LT1 Burb]

I am not, it does not have the part I need.

[contagious102]

LT1 Burb is this what it looks like ? the rod and both ends. May not be the right one ,this longer than 11 5/8" ,this looks like it goes from the column down to the bracket for the 6 banger. I will look for more.!!

[contagious102]

60-66 if you want the carb linkage 30 plus shipping .

[60-66]

Ok, I will take it. Sending pm

Originally Posted by contagious102

60-66 if you want the carb linkage 30 plus shipping .

[LT1 Burb]

Look at part#19 in the picture above , it has 2 ball pivots, one on each end.

[contagious102]

I think the one for the six and the v8 must be different.I will look though.!!