CA Parting 68 Suburban

[cheyenne shortstep]

This thing is rough, fenders, hood, tailgate and front doors are smashed, liftgate is slightly bowed but no rust. Soft-Ray glass, working ram assist steering, truck runs and drives with 350 4spd. Let me know what you need.
No PM's, please keep it in thread to avoid confusion.

[1972 Jimmy]

How much for the rear interior panel chrome trim? Shipped to 48623. Does it have a tach gage cluster or front carpet strip?
Thanks eric

[haskell]

Does it have the little steel cover piece that goes between the two rear panels on the drivers side? Shipping to 46240

Thanks

[uncle]

How are rear door panels? (3rd and dead door). Orig carb/choke and air cleaner?

[ddman6]

How's the rear bumper. How much shipped to 78727?

Dewayne

[diver]

i will take air filter if no dents zip 30141, how to pay

[diver]

i will take air cleaner if no dents ship 30141

[cheyenne shortstep]

72Jimmy- the rear panel retainers are straight but need clean up with steelwool or SOS. I have a factory tach. cluster with one burnt strip on the circuit board that is for the light and no wire harness, the carpet hold down strip needs rechrome and has a slight bow in it. I'll package deal you at $325 shipped.

haskell- is this what your after? If so $15 shipped.

uncle- here is the dead door panel, other side is much worse, here is the air cleaner that is on the truck not sure if this is correct, a couple very slight dents and three 10/32 screw holes, non-original carb./choke.

ddman6- rear bumper sold local, and it was rough.

diver- uncle has first dibs on air cleaner then you're up.

[cheyenne shortstep]

Mo' pics.

[1972 Jimmy]

Will take them all! PM Sent!!

Originally Posted by cheyenne shortstep

72Jimmy- the rear panel retainers are straight but need clean up with steelwool or SOS. I have a factory tach. cluster with one burnt strip on the circuit board that is for the light and no wire harness, the carpet hold down strip needs rechrome and has a slight bow in it. I'll package deal you at $325 shipped.

[47thriftmaster]

I'll get in line on the air intake if not pitted, dents ok. Thanks

[paul mora]

How much for the steering wheel and is it cracked

[diver]

any nice am 67-72 radio

[Arrington01]

I need a original telescope antenna do you have one? I might be interested in tach dash. How much is it?

[72MARIO]

Does it have the factory jack and tire wrench ?

[too much stuff]

How much for the choke delete on the cluster?

[Dirt's72]

How is the shifter boot and ring? Is the washer bottle and bracket any good?

[uncle]

Thx for close up pics. I'm gonna pass.

[xman]

how is the right rear quarter. dont care about dents as long its not rusted out

[haskell]

Yes, that blue piece is just what I am after. I will take it. Please pm with payment preferences.

Tim

[haskell]

I am interested in all door panels. Front, middle and back shipped to 46240. Or whatever is left behind anyone who has already posted.

There did not seem to be any giant rips or holes. Say, not worse than the middle door pics.

If you want to leave shipping open just let me know what you might estimate and we could run with actual cost plus packaging.

[waylonbud]

Hello, I would be interested in the tailgate latch or at least the spring behind the button. Maybe shoot me a price on the whole gate latch button and well go from there. Thank you.

[cheyenne shortstep]

Diver - air cleaner assy $65 shipped, no radio's at the moment.

xman- 1/4 panels are RUSTY.

haskell- do you want just door panels or all int. panels? Right front is missing, right rear door is real bad, rears are so-so. I will get them all pulled and take pics.

waylonbud- no tailgate button at all.

72Mario- no jack/handle

too much stuff- this is all that is there of choke delete. PM sent.

Dirt's 72- here is the shift boot and ring, boot is nice, no cracks, ring same. I have washer bottles and brackets, will dig up the best and can do $45 shipped for it all.

paul mora- steering wheel is cracked and has chunks missing. $50 shipped.

[diver]

pm me thanks,looking to buy stepside rear fender 67-72 with cut out.

[bondo510]

How is the rear seat area rubber floor mat? I need a nice one. I need a front one to but with no shifter holeo