Wiring harness routing

[Rochlow]

Where does the four wire taillight harness pass through the cab? Is it the firewall or the floor?? I can't remember..

[jaros44sr]

Originally Posted by Rochlow

Where does the four wire taillight harness pass through the cab? Is it the firewall or the floor?? I can't remember..

Firewall, push in grommet on wiring should fit the hole

['68 Newtricks]

I was just wondering the same thing. Glad you asked. I think I'll use the oil pressure or washer hole for mine, since I already covered the factory correct hole with my DBW pedal.

Currently wondering how everyone is running the front headlight wires up front. It looks like there is room to tuck it under the top lip of the core support. If I can cut a hole in the vertical braces, it will go from left to right without being seen. How is everyone running it inside the front fenders?

[TBONE1964]

Originally Posted by Rochlow

Where does the four wire taillight harness pass through the cab? Is it the firewall or the floor?? I can't remember..

It will pass through the firewall above the transmission tunnel. I will see if I can find a photo and post it for you.

[TBONE1964]

Originally Posted by TBONE1964

It will pass through the firewall above the transmission tunnel. I will see if I can find a photo and post it for you.

Here you go. Photo is courtesy of another board member.

Hope this helps,
Tom

[Rochlow]

Thanks for the info. I hope I didn't fill that hole. However, I think I can use the washer hole.