|
|
|
03-11-2015, 11:45 AM
|
#1 |
|
Registered User
Join Date: Mar 2015
Location: Danvers, MN
Posts: 70
|
Body Parts
I'm looking towards the future when I'm going to start fixing the rust on me and my dads project 71 and I was wondering where people suggest getting body parts fromm
|
|
|
|
03-11-2015, 12:36 PM
|
#2 |
|
Registered User
Join Date: May 2014
Location: San Diego, CA
Posts: 547
|
Re: Body Parts
You are going to get tons of different responses from people on this question.
Most all of the re-pop panels are about the same quality, so its all hit or miss. I've bought a couple of replacement panels. One of them I trimmed a little off and welded it in. The other one I had to completely rework the entire panel. A lot of people will support the forum sponsors here. Depending on what parts you need, there are a variety of vendors (Summit, Brothers, ECE, LMC, etc) If there is someone local that you can avoid shipping....that's a huge plus. Good luck...send in pictures! |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
