The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 05-18-2015, 12:07 AM   #1
gearheads78
Registered User
 
gearheads78's Avatar
 
Join Date: Aug 2011
Location: Dallas TX
Posts: 563
68 GMC 3/4 ton what are these wire coming out the firewall?

Right around the harness connecter there are 3 single wires that come through the firewall. There was a 305 v6 in the truck originally. I figured out the lower wire was the factory tach but the 2 above I am not sure. The one toward the outside is hot all the time. The one closer to the inside powers up when the ignition is turns on.
Attached Images
 
gearheads78 is offline   Reply With Quote
Old 05-18-2015, 09:39 AM   #2
LockDoc
The Older Generation


 
LockDoc's Avatar
 
Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 25,771
Re: 68 GMC 3/4 ton what are these wire coming out the firewall?

Quote:
Originally Posted by gearheads78 View Post
Right around the harness connecter there are 3 single wires that come through the firewall. There was a 305 v6 in the truck originally. I figured out the lower wire was the factory tach but the 2 above I am not sure. The one toward the outside is hot all the time. The one closer to the inside powers up when the ignition is turns on.

I guess you are going to have to try and follow them and see where they go on each end. The one with the rubber grommet on it looks like it could be a tach wire but I don't think it would be hot all of the time.

LockDoc
__________________
Leon

Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles

(My Dually Pickup Project Thread)

http://67-72chevytrucks.com/vboard/s...d.php?t=829820

-
LockDoc is offline   Reply With Quote
Old 05-18-2015, 03:54 PM   #3
cooperhw
Registered User
 
cooperhw's Avatar
 
Join Date: Oct 2014
Location: Mesa AZ (Near Phoenix)
Posts: 2,302
Re: 68 GMC 3/4 ton what are these wire coming out the firewall?

Quote:
Originally Posted by gearheads78 View Post
Right around the harness connecter there are 3 single wires that come through the firewall. There was a 305 v6 in the truck originally. I figured out the lower wire was the factory tach but the 2 above I am not sure. The one toward the outside is hot all the time. The one closer to the inside powers up when the ignition is turns on.
Looks to me like the group that goes across the firewall with one wire dropping down to the coil (hei?), the others going over and dropping down into the wire clip behind the right head (clip bolts to the transmission bellhousing bolt) large with going to the starter, green wire to the temp. sending unit.
???
Kinda looks like it could be this??
__________________
"Life is too short to drive a boring vehicle".
Later,
Wayne
cooperhw is offline   Reply With Quote
Old 05-18-2015, 08:26 PM   #4
gearheads78
Registered User
 
gearheads78's Avatar
 
Join Date: Aug 2011
Location: Dallas TX
Posts: 563
Re: 68 GMC 3/4 ton what are these wire coming out the firewall?

I guess I was not clear enough. Sorry I am asking about the 2 single wires in the pic. One on the right with the grommet is contant hot and the one on the left with the grommet missing that has the butt connector coming out of the hole. This one powers up with key on. From the factory what were these two wires? Thanks The the long bed camper edition if it makes a difference.
gearheads78 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:41 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com