Complete wood floor kit

[chrismoore701]

Looking for the best place to get a complete oak wood bed kit. Including wood. Strips. And all bolts including large offset bolts. Recommendations?

Thanks

[chrismoore701]

For my 79 stepside

[andrewmp6]

Have you looked at http://www.mar-k.com/index.aspx

[85blustepside]

if your handy at all it is very easy to make the wood.
and much cheaper
wood is 77 1/4 inches long
2 edge boards are 5 1/2 wide
middle boards 7 inches wide

[old Rusty C10]

Originally Posted by 85blustepside

if your handy at all it is very easy to make the wood.
and much cheaper
wood is 77 1/4 inches long
2 edge boards are 5 1/2 wide
middle boards 7 inches wide

What he said I was finding the wood alone for $349 at the lowest I went to lowes and bought 1X8X8 and ripped it down, the cost was just over $100 for the wood then I used a small can of stain and a quart of polyurethane (marine grade) making the whole thing about $175.. If you need strips LMC sells them cheap I personally did the galvanized ones and when I rhinolined the box inner walls I rhinolined them too I used stainless bolts and it looks kinda cool Im doing a shop truck thing so this may or may not work for you

[indianpride77]

Originally Posted by old Rusty C10

What he said I was finding the wood alone for $349 at the lowest I went to lowes and bought 1X8X8 and ripped it down, the cost was just over $100 for the wood then I used a small can of stain and a quart of polyurethane (marine grade) making the whole thing about $175.. If you need strips LMC sells them cheap I personally did the galvanized ones and when I rhinolined the box inner walls I rhinolined them too I used stainless bolts and it looks kinda cool Im doing a shop truck thing so this may or may not work for you

i don't normally work with wood so just curious on what you mean by ripped it?

[TKCR]

Originally Posted by indianpride77

i don't normally work with wood so just curious on what you mean by ripped it?

It means he cut the 1x8x8 down to the size he needed for the rails. You cut them down using a table saw.

[85blustepside]

Yes we bought mine at a lumber yard for about 100?
Also got marine grade poly going to drill the holes and apply the 4th coat.
its going to get installed Tuesday night

Here is a picture after the first coat.

[chrismoore701]

Was able to piece it together at Classic Parts of America. What do you guys think for the hardware? Just stainless or polished stainless?. Frame off restoration show truck, but will drive it

[bbbc10]

Get what YOU want to have on your truck man

[chrismoore701]

I found the wood at Classic Parts for $280 drilled and the hardware for and strips about $450 out the door for everything. Oak floor. Not sure if I am going to use polyurethane, or clear it.

[85blustepside]

this was done with a table saw
no router needed you could use a router and might be easier