|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
09-07-2017, 04:47 PM
|
#1 |
|
Registered User
Join Date: Sep 2008
Location: magalia,ca
Posts: 366
|
Lower Control Arm Bump Stops
Im in the process of replacing mine on my gmc
got the old ones out. But cant get the new ones in. They are the push though triangle shaped ones. Whats the trick to getting them in?
__________________
1970 2wd  3/4 ton- 2004 crate 350 thorley tri-y headers-edelbrock performer eps manifold 600cfm performer carb, crane cams energizer cam,lifters, dual 2.5 magnaflows, mallory HEI, powermaster 140 amp altenator, griffen aluminum radiator.(8 MPG )
|
|
|
|
09-07-2017, 04:57 PM
|
#2 |
|
Senior Member
 
Join Date: Oct 2014
Location: New Palestine In
Posts: 932
|
Re: Lower Control Arm Bump Stops
Try a good dose of dish soap and a flat bladed screw driver to push it through.
__________________
Phil "Money is only a tool to create and achieve what you want most in life" PayPal: rodnrudy@comcast.net |
|
|
|
|
09-07-2017, 05:01 PM
|
#3 |
|
Senior Member
Join Date: Dec 1999
Location: Spring Valley, Ca.
Posts: 1,136
|
Re: Lower Control Arm Bump Stops
Ruined one using lubricant and Flat blade screw driver. Use the lube, but find a c-clamp that will reach the bump stop and use it like a press. It was a snap doing it this way. Minutes as opposed to fighting that thing for a half hour or more with a screw driver and them having to throw it away and starting over with a new bump stop.
__________________
Smitty '71 Short Fleetside Spring Valley, Ca. |
|
|
|
|
09-08-2017, 04:35 PM
|
#4 |
|
Registered User
Join Date: Aug 2009
Location: St. Paul MN.
Posts: 1,996
|
Re: Lower Control Arm Bump Stops
put silicone lube on the bump stop put in place and jack up the control arm till it bottoms out the bump stop. done
__________________
Fuzzy |
|
|
|
|
09-08-2017, 07:43 PM
|
#5 | |
|
Registered User
Join Date: Sep 2008
Location: magalia,ca
Posts: 366
|
Re: Lower Control Arm Bump Stops
Quote:
__________________
1970 2wd 3/4 ton- 2004 crate 350 thorley tri-y headers-edelbrock performer eps manifold 600cfm performer carb, crane cams energizer cam,lifters, dual 2.5 magnaflows, mallory HEI, powermaster 140 amp altenator, griffen aluminum radiator.(8 MPG)
|
|
|
|
|
|
09-08-2017, 09:06 PM
|
#6 |
|
Registered User
Join Date: Feb 2015
Location: TX Hill Country
Posts: 150
|
Re: Lower Control Arm Bump Stops
I sprayed mine with silicone and then proceeded to beat them into submission with a rubber mallet. I like some of the other methods presented above better.
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
