|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
09-19-2017, 08:17 PM
|
#1 |
|
Registered User
Join Date: Dec 2011
Location: Massachusetts
Posts: 245
|
Front crossmember to upper control arm studs
So I searched and searched, and have a vague idea but wanted to check. To replace these two studs, do I just have to pound them out? And pound in new ones?
Last edited by Bloodhound; 09-19-2017 at 08:23 PM. |
|
|
|
09-19-2017, 08:35 PM
|
#2 |
|
Registered User
Join Date: May 2012
Location: horseheads,ny rust belt
Posts: 2,794
|
Re: Front crossmember to upper control arm studs
think of them just like a wheel stud .
heck they might just be a wheel stud from like a drw 1ton axle rear . real long for the length . but I am not sure of this fact .
__________________
77-k30lb BIG truck build . 87-k30lb budget beater build . 85-k30lb the plow machine build . 85-c10sb summer fun toy . ----------------------------- HOLLEY SNIPER efi = worst case of p.i.t.a i ever had . EDELBROCK pro flo 4 = best deal going so far . love my setup works great. |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
