How did you remount your bed?

[Angrywood]

I’m pretty much done redoing my bed wood. Now I’m looking at how to get the bed back up on the frame? I’m thinking of doing an engine hoist to lift it and move it into position. How did you guys do it? That bed is heavy as heck with all the new wood. So lifting it by hand might be pretty hard for me and one other person.

[mongocanfly]

me and a buddy pulled mine...but 4 people ,one on each corner, would be better

[vin63]

I have a bed lift that is basically a large "H" with adjustable arms that fit under the lip of the bed sides. It has a loop in the middle for either a shop crane or a trolly lift. I used my shop crane when I was mocking things up since I had more help then (holding it from swaying) and then used the cross bar on my lift with a couple of ratchet straps when I was setting it on the chassis for good since I was by myself.

[jayoldschool]

I've done two. On mine, I left out a couple boards, and used my engine hoist and a strap to get it in place. On the second truck I did the bed vertical to save time on the board bolts, so I rounded up a few buddies to flip lower the bed to horizontal and up on the truck.

[PGSigns]

Once with the lift arms and straps and once with four guys. Both methods worked fine.
Jimmy

[Angrywood]

Thanks for the replies. Looks like im doing the engine hoist route. Just wanted to see if there was another way besides brute force and the hoist.

[sstock]

I too have a four post lift, but used it to lower the truck off the bed instead of raising the bed off the truck. 4 straps to eye bolts from the bottom of the trusses used. After removing the truck, I then raised the lift up to sit the bed on it,which made it a cinch to disassemble.
Steve

[rws1012]

I looked at one of the metal bed lifting tools made by Eastwood. I went to my lumber pile and took 1 4x4 and 2 2x4s and built one . Picked up a large eyebolt and drilled a hole in the 4x4. Used my homebilt gantry crane and lifted the bed off and then back on . Worked great. An A -frame or cherry picker will also do the job. Good luck

[sstock]

Good point, I could of used my gantry and trolley but that would of put the lift point in one place. Then you have to deal with keeping the bed level and not moving- swaying too while trying to install it with new paint an so on. Unless you could get some help. If you are helpless like me then it is different

[Paul Y]

The joys of having my 3 sons living with me, cheaper than paying rent!

P.

[Chevy Fleetside]

I have used engine hoists and either straps or made a wood H frame as stated in another post. When I did this bed wood I never took the bed off the truck.

[62bagger]

I used a wood H frame and engine hoist. Had the bed off twice like this. It works great but extra hands will make it easier.

[Getter-Done]

Here's an Old thread full of info.

Link: https://67-72chevytrucks.com/vboard/...light=bed+lift