|
|
|
09-16-2020, 08:33 PM
|
#1 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,064
|
Sway Bar Width?
Is there an S10 aficionado in house that might have a sway bar they could measure the width (end-link center to end-link center)?
I measured an aftermarket C10 spec bar as well as a 3rd GEN f-body 1Le/36mm bar by placing them on the garage floor surface & marking the concrete w/a Sharpie. I want to compare an S10 as well.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
10-12-2020, 11:06 AM
|
#2 |
|
Registered User
Join Date: Dec 2013
Location: Columbus, Oh
Posts: 367
|
Re: Sway Bar Width?
I can help you with that. I will send a PM
|
|
|
|
|
10-12-2020, 11:12 AM
|
#3 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,064
|
Re: Sway Bar Width?
I was able to measure one off of a 94-02 S10 truck. It was ~41.5 which was still too wide for my application @ ~39".
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
10-12-2020, 11:46 AM
|
#4 |
|
Registered User
Join Date: Dec 2013
Location: Columbus, Oh
Posts: 367
|
Re: Sway Bar Width?
Ok.
|
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
