NP205 Install Tips

[K20-Bowtie]

SM465 & NP205 on 72 K20 - leaking from many points. Decided to yank both out (pic attached).

A buddy of mine helped me reinstall a rebuilt SM465 - took some finesse to line up transmission shaft, but it's in and bolted down.

In the process of cleaning up NP205 and replacing seals. Any tips on reinstalling transfer case by myself? Have a transmission jack.

[kwmech]

Get a couple of double ended studs and place them across from one another where putting a nut on the adapter is accessible. I used to bench press them, but I'm getting too old for that sh.. (with the 205 weighing in at 156#)anymore. Make/weld up a plate that will bolt to the jack and bolt to the t-case at the approximate angle.

[jaros44sr]

I used exhaust manifold studs, they have a small hex head to put a wrench on , helps alignment, also i put the crossmeber on, helps to stabilize the 205 on the trans jack

[Accelo]

I built a flat plate with flat bar welded to it.
I could bolt the flat plate to the jack.
The flat bar has holes in it that match some on the transfer-case.
That way I could tilt it with out worrying if it going anywhere.
The are heavy and very dangerous if you drop it.

If I remember correctly the speedometer output doesn't even have a seal on it.
Things have changed since the 70's! Some things are even better.

A friend called me today wondering what do do as an acquaintance broke the case of his manual 5 speed and dropped the transfer-case to the ground. Oh to be young again out stump humping. LOL.
Rick

[72Cheyenne454]

After years of manhandling NP205's into position, I finally built a jig that fits into my floor jack. Makes it so much easier. Unfortunately, I just had to use it, as my transfer case adapter seals were leaking and I was getting ATF in the tcase.

Miles

[57taskforce]

Originally Posted by 72Cheyenne454

After years of manhandling NP205's into position, I finally built a jig that fits into my floor jack. Makes it so much easier. Unfortunately, I just had to use it, as my transfer case adapter seals were leaking and I was getting ATF in the tcase.

Miles

Love that jig that is pretty sweet. They suck to put in by yourself with no jack. I’ve bench pressed a few of them. Is that an old school harbor freight floor jack? My dad had one just like that for a long time, he said it was from the late ‘80s.

[DeadheadNM]

Good time to replace the speedometer seal and adapter nut O-ring. Torque King sells both (there are two seal sizes): https://torqueking.com/product/30065...ransfer-cases/

I just changed these out on my Blazer and no more leak.

[57taskforce]

LOL yea my dad had his when I was a kid in the late 80’s-early 90’s all the way up till about 5 years ago. Lived it’s whole life in gravel haha. When he finally killed it off, It was almost like the loss of a family heir loom

[Richard]

Having removed and installed a 205 t-case several times. I will note that a transmission jack makes it no easier without some kind of jig.