Windshield gasket

[twoskies]

Morning

Got a 66 c10. That I’ve replaced the inner roof and the outer front upper panel
I replaced the inner roof first. Leaving the outer front panel in place for reference
Then when I was ok with the fit. Welded the inner roof in place
Then with the inner roof stable.
Cut and replaced the front outer roof section in
I want to be sure I have not changed the pinch seam
I’m trying to put a windshield in to check. New gasket
Here’s the problem
I can’t get the gasket to start I’ve watched several videos. Some use glass cleaner some use soapy water some use nothing
Including two pictures. Assuming the small opening goes to windshield bigger goes to outer around the frame. Makes sense
I’ve left outside in driveway for a few hours. No difference
Might try a heat gun

Thanks for any help

[Wrenchbender Ret]

First use a high quality gasket like "Steele Rubber". I had a glass man put mine in after I bought the windshield & gasket. He was amazed how much better it fit & easier to install then the cheap ones he had been using.
Also silicone spray will be the best lubricant but if you are going to paint anything around there in the future don't use it. It will ruin a paint job.

George

[slorio]

Twoskies:
I used white lithium grease after my glass guy gave up...

Read all about it here:
http://67-72chevytrucks.com/vboard/s...d.php?t=833869
Regards
Steve
New Orleans

[twoskies]

Hey
Thanks for the replies

I got it. Had to use a plastic knife on both sides. But it worked

Got the rope in

Waiting a couple days to install