NC WTB Wiring harnesses in good condition

[ScottH]

Looking for 2 wiring harnesses for a 63 C10. First 1 is the taillight harness that runs from the firewall all the way to the back. Second 1 is the engine harness that goes from firewall to the starter, gauges, etc. I know these r available aftermarket but I just need them to get the truck on the road until I do a complete rewire next year.

Any info is appreciated.

[bhap]

Just a suggestion, but you can buy the Packard 56 terminals and plug housings (if needed) and repair the harnesses you have - or just make your own. Depending on your distributor, you may need to remove resistor wire anyway.. not too difficult if you have a decent wiring diagram. There are several available on this website.

[DPowers]

Originally Posted by ScottH

Looking for 2 wiring harnesses for a 63 C10. First 1 is the taillight harness that runs from the firewall all the way to the back. Second 1 is the engine harness that goes from firewall to the starter, gauges, etc. I know these r available aftermarket but I just need them to get the truck on the road until I do a complete rewire next year.

Any info is appreciated.

Probably have what you need but wont be back to TN until 11/19.
Email me at dwanepowers@att.net

[pimpston65]

Hello, just checking to see if you still need the engine harness? I have an NOS harness for V8 with lights

[ScottH]

Thanks pimpston65 but turns out that I now need 1 for a 66 with manual gauges.

[pimpston65]

Originally Posted by ScottH

Thanks pimpston65 but turns out that I now need 1 for a 66 with manual gauges.

ok, i will check my stash. 66 w/gauges got it... engine side.