![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Before and After
Join Date: Feb 2000
Location: Leduc, Alberta CANADA
Posts: 632
|
Factory bench Question
The rigid wire that connects the two sides of the mounting brackets has been taken off.
I want to put it back on, I think I remember that it went through some hog rings, is that true? If so how many? The wire is too long if it doesn't. I know that I don't need it if I don't want to adjust the seat, and Iprobably won't adjust it, I would just like it back on. Photos?
__________________
Not Grandpa's C-20 anymore... 383 Stroker 425HP, 485Ft/Lbs Lowered 3.5" Front / 5" Rear 66,000 miles. Alberta, CANADA |
![]() |
![]() |
![]() |
#2 |
Merciless Butcher
Join Date: Oct 2003
Location: CC Nevada
Posts: 1,447
|
That sounds right. The hog ring was used to keep the wire up and out of the way.
__________________
Your Bought And Sold....I Got Your Soul! |
![]() |
![]() |
![]() |
#3 |
Senior Member
![]() Join Date: Mar 2000
Location: Rockville,In. USA
Posts: 3,720
|
Actually there should be a small metal loop attached to the bottom of the seat springs midway across the bottom of the seat that it slides through before connecting on either side.
GMCPaul |
![]() |
![]() |
![]() |
#4 |
Before and After
Join Date: Feb 2000
Location: Leduc, Alberta CANADA
Posts: 632
|
Does it go through just one hog ring?
__________________
Not Grandpa's C-20 anymore... 383 Stroker 425HP, 485Ft/Lbs Lowered 3.5" Front / 5" Rear 66,000 miles. Alberta, CANADA |
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Jul 2000
Location: NC
Posts: 987
|
Mine goes through only one hog ring...if it still has too much slack to adjust the seat back and forth, put it through another hog ring.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|