|
|
|
02-29-2004, 10:55 PM
|
#1 |
|
Registered User
Join Date: Jan 2001
Location: maiden nc usa
Posts: 162
|
gas guage
got power at gauge still not working any suggestions
|
|
|
|
02-29-2004, 11:14 PM
|
#2 |
|
Registered User
Join Date: Jul 2003
Location: Cypress, Tx
Posts: 4,005
|
Make sure you have a good ground. The stud that does not mount to the circuit card should be grounded to the gauge cluster. I would try and run a wire from that stud to a good gound elsewhere, since the gauge cluster doesn't always ground too good.
__________________
1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE |
|
|
|
|
02-29-2004, 11:16 PM
|
#3 |
|
Careful, they attack...
Join Date: Aug 2001
Location: Waterford, MI, USA
Posts: 1,107
|
Check the ground on the gauge, also check the wire going from the sending unit. If you have a meter, check it for continuity. I have a new gauge if you need one also. Mine have all been tested and are known to work. If you check from the sending unit wire to ground, you should have between 0 and 100 ohms depending on how much gas you have in the tank. If you don't, then your sending unit could be bad. Take it out and check to see if the float has filled with gas and is sitting at the bottom.
|
|
|
|
|
02-29-2004, 11:43 PM
|
#4 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Where is your needle pointing? This will tell you where to look for the problem.
|
|
|
|
|
02-29-2004, 11:47 PM
|
#5 |
|
Registered User
Join Date: Jan 2001
Location: maiden nc usa
Posts: 162
|
its pointing at 1/8 tank
|
|
|
|
|
03-01-2004, 12:50 AM
|
#6 |
|
Registered User
Join Date: Jun 2002
Location: Knoxville Tenn.
Posts: 3,058
|
Hey purple69 check out new thread--"gas gauge fixed!!"-- might help you out.
__________________
56 Chevy Bel-Air 2dr. HT (purchased new) 71 Chevy Cheyenne SWB PU (502HO) 65 GMC short bed step--work in progress and my gofer |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
