Chrome drip rail molding Help!!!! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Harold Shepard · 11-20-2004, 09:20 PM

I tried this just after I finished my 71 super, but I scratched paint and got pisse and wadded the moldings up and threw them in the dumpster, and repainted the rails. I just got through looking at ECE's web page about spindles for my other truck and looked at pics. -long story short I want to put the moldings on again... does anyone one have any advice, tips etc. for me before I shell out $120 bucks again. Thanks Harold

slogo · 11-20-2004, 10:17 PM

Tape off the paint around the area your going to put the molding with some good 3M tape and take it slow, double it if you have two. you might need a helper, extra set of hands might be the answer.

**FRENCHBLUE72** · 11-20-2004, 10:24 PM

Here are a few pointer's from the golden state builder's guide..
#1 make sure there is no excess caulking or paint build up between the roof and rail.
#2install the door section's first starting at the upper most corner.
#3 when the uppermost corner is in place fasten the rear mouldingall the way down to the lower edge.
#4after the rear is attached,do the same along upper edge about half way.

They suggest using a soft rubber hammer to press the moulding on firmly...

Hope this help's you out..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-20-2004, 09:20 PM	#1
Harold Shepard Registered User Join Date: May 2004 Location: Canton North Carolina Posts: 466	Chrome drip rail molding Help!!!! I tried this just after I finished my 71 super, but I scratched paint and got pisse and wadded the moldings up and threw them in the dumpster, and repainted the rails. I just got through looking at ECE's web page about spindles for my other truck and looked at pics. -long story short I want to put the moldings on again... does anyone one have any advice, tips etc. for me before I shell out $120 bucks again. Thanks Harold

11-20-2004, 10:17 PM	#2
slogo Registered User Join Date: Mar 2003 Location: Morristown,TN Posts: 482	Tape off the paint around the area your going to put the molding with some good 3M tape and take it slow, double it if you have two. you might need a helper, extra set of hands might be the answer.

11-20-2004, 10:24 PM	#3
FRENCHBLUE72 PROJECT 7DEUCE Join Date: Dec 2002 Location: GRANTS PASS OR Posts: 21,604	Here are a few pointer's from the golden state builder's guide.. #1 make sure there is no excess caulking or paint build up between the roof and rail. #2install the door section's first starting at the upper most corner. #3 when the uppermost corner is in place fasten the rear mouldingall the way down to the lower edge. #4after the rear is attached,do the same along upper edge about half way. They suggest using a soft rubber hammer to press the moulding on firmly... Hope this help's you out.. __________________ GO BIG GREEN GO DUCKS MEMBER #6377 72 k-5 daily driver 6'' lift 35'' 350-350-205 slowly getting rust free. Project "7DEUCE" check out my build http://67-72chevytrucks.com/vboard/s...d.php?t=267665 Tim Powell..R.I.P EastSideLowlife..... R.I.P..



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.