![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Nov 2003
Location: kc
Posts: 229
|
gauge cluster compatability question
i currently have the gauge cluster with just the speedo and fuel gauge in my truck. i have a gauge cluster im restoring with everything except tach and vacuam. will i have to replace the wiring harness to install this gauge cluster or can i run individual wires to the oil, water and temp.? i read on the parts board someone had problems burning up their wiring hareness when they did not switch harenesses?
__________________
71 C10 SWB BLACK AND WHITE 350 CRATE TH350 ENJOY LIFE |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
![]()
I am not sure why the harness burned up unless it was mis-wired. You can wire individual wires for the gauges but going with a gauge harness sure simplifies things. Also, down the road when problems arise, it is much easier to follow the factory wiring. I would recommend replacing the harness.
Jim |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Oct 2004
Location: saskatoon, planet earth
Posts: 691
|
Aparently if you just plug in your new cluster, you'll get a smoke show. Don't want that!! There is a detailed schematic of how to convert your wiring so the dash will work But I don't know where.. Have patience grasshopper.. I'm sure someone will post the link on here.
|
![]() |
![]() |
![]() |
#4 |
CCRider
Join Date: Feb 2000
Location: Olive Branch,MS,USA
Posts: 2,232
|
__________________
72 GMC Sierra SWB almost finished---- 84 Softail Olive Branch MS |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|