streching panels that arent accesible from behind - The 1947 - Present Chevrolet & GMC Truck Message Board Network

ymhjrhd · 07-28-2005, 02:52 AM

Can anyone give me so info on how I can get a warped panel back to its old flat self after being welded on. I took all the proper precautions and I still had warpage when I welded on a drivers side bed replacement panel. I took my time and made sure that the patch panel fit snugly and tacked every inch then ground down the tacks and welded between, but still the bedside warped on me. I cant access the inside of the bed so am I up a creek? Any help would be appreciated. Sorry about the terrible format of this question.

ymhjrhd · 07-28-2005, 10:24 PM

I just went and bought one today. thanks

07-28-2005, 02:52 AM	#1
ymhjrhd Registered User Join Date: Jun 2005 Location: Spokane Wa Posts: 20	streching panels that arent accesible from behind Can anyone give me so info on how I can get a warped panel back to its old flat self after being welded on. I took all the proper precautions and I still had warpage when I welded on a drivers side bed replacement panel. I took my time and made sure that the patch panel fit snugly and tacked every inch then ground down the tacks and welded between, but still the bedside warped on me. I cant access the inside of the bed so am I up a creek? Any help would be appreciated. Sorry about the terrible format of this question.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-28-2005, 10:24 PM	#2
ymhjrhd Registered User Join Date: Jun 2005 Location: Spokane Wa Posts: 20	I just went and bought one today. thanks



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.