Painless wireing questions....

[FRENCHBLUE72]

I have installed a 18 curcuit 67-72 p/n#10206 painless harness in my blazer and have a few questions for those who have installed these kits..

Where did you hook up the gear indicator light and the heater controll light??

All the acc port on the fuse box are hot all the time is that correct or do I have something hooked up wrong???

Any help would be great...

[68 short step]

not much help here, but how does it pass through the firewall? is it a bulkhead connection or just wires going through a grommet? and bout how much did that cost?

[FRENCHBLUE72]

The wires pass through a bulk head but it is larger than the stock one so cutting is required and the stock taillight harness hole is not used so you have to fill it in with a rubber groument.. Cannot remember price right off the top of my head got it at summit racing though..

[BubbaGreen]

tie into the dash lights....that way they will only be on when the lights are on.

[raidermanny]

Thats how I wired mine too.

[jhow66]

Only things that should be hot with switch off are -brake lights-headlight switch- hazzard lights-dome circuit. Check large pink wire to ing. switch (this wire feeds fuse panel). It should not be hot at ing. switch with switch off. Back side of switch will have Acc. post on it.