![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
![]() Join Date: Dec 1999
Location: Darrington, Washington
Posts: 3,963
|
![]()
I know ive asked this before to make sure before i bring the Rat back to life i bought a Melling Oil Pump,but it came with no munt gasket,and nobody even lists one.not even summit,why i am curious is because the old pump had one,unless someone made it.Im not a engine bottom end expert so any info would be appreciated,i think i asked several months ago,but since i cant remember yeasterday-well you know blah blah!!
|
![]() |
![]() |
![]() |
#2 |
Gasser
Join Date: May 2000
Location: Thomasville,NC USA
Posts: 456
|
![]()
I've never used a gasket there. Just draw file the surfaces to insure flatness..
------------------ 70 sstep tubbed, Muncie 68 swb LT-1
__________________
:thud 70 sstep tubbed, Muncie, double hump, snowflake, |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Dec 2001
Location: Spring Creek, nevada. U.S.A.
Posts: 456
|
![]()
they don't have a gasket, just the machine finish.the big block bock i have does say to use permatex gasket maker num. 2 on it to make a good seal.thats what i did with mine.
------------------ project 70 chev swb rebuilt 396bb{402}rebuilt th-400 3.73 limited slip 4/5 drop
__________________
69 chevy short wide box project 70 GMC jimmy project |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Apr 2000
Location: Delta,Pa
Posts: 14,950
|
![]()
dont use a gasket on sbc not needed
------------------ 72 chevy lwb 350 lunati cam ported and polished cast 2.02 heads proform hei edelbrock performer rpm and 750 carb balanced bottom end 9.5:1 compression ps,pb th350 with a tci 2500 stall convertor full man v-body kevlar clutches and bands as well as other goodies
__________________
Owner of North Point Car Care in Dundalk Md. We specialize in custom exhaust on both modern and classic vehicles. We are a full service auto shop from classics to modern vehicles. Feel free to contact me with questions. I will give a 10% discount to any board member. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|