|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-08-2007, 05:58 PM
|
#1 |
|
Senior Member
 
Join Date: Aug 2004
Location: Centennial, CO
Posts: 2,990
|
Good driveshaft shops in DFW?
So, anyone have a recommendation for a good driveshaft shop in the DFW area? I need one shortened a bit and a new carrier bearing installed while it's there.
__________________
ClusterTruck: 68 C10 Bought in 89, wrecked in 03. Slow low $ rebuild started '17. 6.0 & TKO http://67-72chevytrucks.com/vboard/s...d.php?t=788602 93 K1500 Short Step, 350, NV4500, EBL flash ECU. Vortec heads & roller cam someday... 05 Jeep Wrangler Unlimited. 3” lift & 6-speed 02 E320 the insurance total “free car” 13 Tahoe LTZ Last edited by clay68c10; 04-08-2007 at 05:59 PM. |
|
|
|
04-08-2007, 06:10 PM
|
#2 |
|
Watch out for your cornhole !
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: Good driveshaft shops in DFW?
I've had Fort Worth Gear and Axle do a bunch of mine. Never a complaint.
__________________
I'm on the Instagram- @Gearhead_Kevin |
|
|
|
04-08-2007, 07:16 PM
|
#3 | |
|
Registered User
Join Date: Sep 2002
Location: DFW Texas
Posts: 2,269
|
Re: Good driveshaft shops in DFW?
Quote:
Another vote for Gear and Axle. They do all mine. |
|
|
|
|
|
04-08-2007, 07:47 PM
|
#4 |
|
Registered User
Join Date: Dec 2006
Location: Texas
Posts: 22
|
Re: Good driveshaft shops in DFW?
I've used Driveshaft King in Dallas & am very satisfied with there product.
__________________
 70 Chevy LB
|
|
|
|
|
04-08-2007, 10:08 PM
|
#5 |
|
Registered User
Join Date: Nov 2005
Location: VIRGINIA
Posts: 905
|
Re: Good driveshaft shops in DFW?
im wondering how much they charge to shorten a driveshaft, iv had a couple done but this last time seemed alil steep, thanks
__________________
1969 rs 1966fastback 1969swbc/10 2006gt 1972swb4x4 |
|
|
|
|
04-09-2007, 12:05 AM
|
#6 |
|
The oddest Todd around
Join Date: May 2004
Location: Miami, Florida
Posts: 1,418
|
Re: Good driveshaft shops in DFW?
I had Fort Worth Gear and Axle build me a custom one piece drive shaft to replace the two piece one in my 72 lwb, it was just under 300 installed. You could always go that route.
Todd
__________________
"The greatest pleasure is to vanquish your enemies and chase them before you, to rob them of their wealth and see those dear to them bathed in tears, to ride their horses and clasp to your bosom their wives and daughters." Ghengis Khan IIOY??? |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
