Flaming river tilt column - The 1947 - Present Chevrolet & GMC Truck Message Board Network

70chevyboy · 05-30-2007, 10:15 PM

Im working on a 1970 chevy and i pulled the factory steering column and I am putting a flaming river tilt column with column shift for a 700r4.I called falming river and was told if i use the factory drop itll be below the dash and the only way to get it in the factory position was to use the factory bracket.Is this true?the other thing is are the slpines on the shaft diff, because it doesnt seem to wanna go in i guess its called the rag joint maybe.Any help from past installers would be much appreciated.

70chevyboy · 05-31-2007, 04:41 PM

Anyone at all???

05-30-2007, 10:15 PM	#1
70chevyboy Registered User Join Date: May 2007 Location: california Posts: 2	Flaming river tilt column Im working on a 1970 chevy and i pulled the factory steering column and I am putting a flaming river tilt column with column shift for a 700r4.I called falming river and was told if i use the factory drop itll be below the dash and the only way to get it in the factory position was to use the factory bracket.Is this true?the other thing is are the slpines on the shaft diff, because it doesnt seem to wanna go in i guess its called the rag joint maybe.Any help from past installers would be much appreciated.

05-31-2007, 04:41 PM	#2
70chevyboy Registered User Join Date: May 2007 Location: california Posts: 2	Re: Flaming river tilt column Anyone at all???

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.