|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-20-2007, 01:22 PM
|
#1 |
|
Registered User
Join Date: Feb 2005
Location: Carl Junction, Missouri
Posts: 2,061
|
5 inch rear drop question
without lowering blocks i have less than an inch from the bump stop. did yall cut off the bump stop?
|
|
|
|
07-20-2007, 01:54 PM
|
#2 |
|
Worthless
Join Date: Jun 2006
Location: LaFayette, GA
Posts: 199
|
Re: 5 inch rear drop question
I have 5 inch drop springs on mine,I left the bump stops and do not bottom out but I do not carry a load in mine!!!!
 
|
|
|
|
|
07-20-2007, 02:03 PM
|
#3 |
|
Senior Member
 
Join Date: Jun 2002
Location: Murray, Kentucky
Posts: 3,476
|
Re: 5 inch rear drop question
I have a 6" drop and I cut mine down.
Rg
__________________
Roger '68 Short step - https://67-72chevytrucks.com/vboard/...d.php?t=849675 '69 ('70?) 2wd Blazer '70 GMC Jimmy 2wd '73 Firebird - https://67-72chevytrucks.com/vboard/...d.php?t=853203 |
|
|
|
|
07-20-2007, 03:44 PM
|
#4 |
|
On the road
 
Join Date: Jan 2004
Location: NATCHITOCHES LOUISIANA
Posts: 818
|
Re: 5 inch rear drop question
I have a 4/6 drop and had to cut mine down as well.
Mike
__________________
Mike Castro- 72 SWB. Ochre and White. 496/400 turbo, GV OD ,Dakota Digital dash , tilt, Vintage Air, PS, hydro boost, factory buckets, console, QA-1 Coil over suspension, 20/20"Billet Specialties Magnetos 72 SWB. Med blue. 454/400 turbo, tach, tilt, Stock AC, PS,PDB, factory buckets, console, ECE 4/6 drop w/ 2" blocks and C-notch, 20/20"Coys- Crashed and destroyed by drunk driver Sept 2019. New 72 build in the works. My new build thread "Castro" https://67-72chevytrucks.com/vboard/...d.php?t=820934 My old build thread, the blue truck http://67-72chevytrucks.com/vboard/s...d.php?t=271489 www.louisianaclassictruckclub.com |
|
|
|
|
07-20-2007, 04:35 PM
|
#5 |
|
Registered User
Join Date: Feb 2005
Location: Texas
Posts: 581
|
Re: 5 inch rear drop question
I have a 4" in mine and everytime i put a load on it it drops but doesn't hit the bump stops. I am thinking about bagging the rear. I am installing a rear fuel cell and i don't know if the rear spring will sag if I put a load on it with the fuel cell. bagging the rear should prevent it.
__________________
1972 Cheyenne 402 LWB 2005 Silverado X-Cab 5.3L 2004 John Deere L120 20HP B&S |
|
|
|
|
07-20-2007, 04:51 PM
|
#6 |
|
Registered User
Join Date: Jul 2005
Location: AL
Posts: 1,828
|
Re: 5 inch rear drop question
yes.. .putting the gas tank in the rear plays a part... esp. with a full 25 gals.
with a 6in drop in the rear the bump stops need to be cut..otherwise its a jolt to go over railroad x-ings
__________________
" |
|
|
|
|
07-20-2007, 08:05 PM
|
#7 | |
|
Senior Member
Join Date: Mar 2007
Location: VANCOUVER ISLAND, B.C., Canada
Posts: 1,602
|
Re: 5 inch rear drop question
Quote:
Nice truck, I like the stance & the rake. esll.
__________________
Tomorrow is for doing today's stuff.  ************************************* This truck has just the right amount of energy for me! Author: Warren Lake .... (member) Last edited by EAST SIDE LOW LIFE; 07-20-2007 at 08:06 PM. |
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
