![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
yes, i do
Join Date: Jun 2007
Location: Spokane, wa
Posts: 2,734
|
project problem child, update
so i finished the bed swap, although its still missing the floor in the bed, but that's nothing a sheet of plywood can't fix. so i went to the local wrecking yard just outside of base, which they almost know me by name(is that sad?) and i picked up some old rims of a 70's short bed gmc. these are the kind of rims that i have been wanting and all i paid was 50 bucks! but here comes the catch, they're dirty, chrome peeling off, one has almost no chrome left, blisters in the chrome, rust and galvanic corrosion(thank god i was in the corrosion control shop in my squadron) not to mention bad tires. but what else could i expect from $50 junk yard rims. so now the plan is to clean them up and give them a nice healthy coat of paint. so after i get off watch and go and pick up an edelbrock 1406 for $100 i will post some photos of the one that i cleaned(thank god i started with the bad one) and the next worse one. so all i gotta say now is EAT YOUR HEART OUT EL CHEAPO!!! hahaha. sorry sal, i couldn't really resist. but as i see parts i will let everyone know what's there and what is possibly still useable.
|
![]() |
![]() |
![]() |
#2 |
yes, i do
Join Date: Jun 2007
Location: Spokane, wa
Posts: 2,734
|
Re: project problem child, update
well i didn't manage to whip out the camera after i finished the rims. i'm gonna do it in the morning after duty section muster. but i did manage to figure out what that knock is/was that i mentioned in a previous thread. me and a few buddies looked at the motor while running and determined it to be a bad main bearing(s) due to the deep knock and lack of oil psi when warm(10 psi or less when warm for the guys who don't know). kinda bad news i know but this just means that now i can do what i want to do to the motor with justification. like a new comp cams magnum 280h grind cam, knife edge the crank, and possibly replace the intake manifold for a performer rpm or rpm air gap. the only hang up on this one is the fact that i leave for nevada on tuesday so its gonna have to wait till october for me to do it.
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|