|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-23-2007, 06:52 PM
|
#1 |
|
Senior Member
 
Join Date: Jun 2007
Location: Pine Ridge Florida
Posts: 4,134
|
Blaser/Jimmy rubber body mounts.
I am installing a set of GMC Pauls body mounts. The sleeve is shorter than the stock one. If I use the ones that come with the kit the rubber mount that goes on the bottom of the frame gets compressed a lot. If I use the original one it barely compresses at all. Anybody have a picture of a bottom rubber mount installed please? I am looking for one of the back/rear ones.
Thanks Mark |
|
|
|
09-24-2007, 12:28 PM
|
#2 |
|
Post Whore
Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,686
|
Re: Blaser/Jimmy rubber body mounts.
My mounts compressed alot but when I asked about it about two years ago I was told that was okay.
__________________
1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 |
|
|
|
|
09-24-2007, 04:12 PM
|
#3 |
|
Senior Member
Join Date: Jun 2007
Location: Pine Ridge Florida
Posts: 4,134
|
Re: Blaser/Jimmy rubber body mounts.
thanks
|
|
|
|
|
09-24-2007, 06:33 PM
|
#4 | |
|
Registered User
Join Date: Oct 2003
Location: Central Vermont
Posts: 8,537
|
Re: Blaser/Jimmy rubber body mounts.
Quote:
 only to add...watch the overall alignment.
|
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
