|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-22-2007, 04:21 AM
|
#1 |
|
Senior Member
Join Date: Jun 2003
Location: Westminster, CO
Posts: 3,071
|
For anyone interested, a link to my Powdercoat Oven build
I'm building a Powdercoat oven and have found a wealth of information on the Caswell site. Anyone wanting to see my oven being built the link is below.
Alex http://forum.caswellplating.com/showthread.php?t=7525
__________________
Alex 1971 Lil' Red 350 SBC 700R4 Last edited by ChevyDude; 12-22-2007 at 12:00 PM. |
|
|
12-22-2007, 04:32 AM
|
#2 |
|
67-72 Addict!
Join Date: Feb 2002
Location: The TAX State!
Posts: 7,856
|
Re: For anyone interested, a link to my Powdercoat Oven build
Lookin' great Alex!. Did you double up the 2" Roxul or did you buy 4" thick sheets?.
__________________
Jim 1970 C/10 Fleetside w/Ghost Flames Lowered 4.5" front and 4" rear (Raked) 355/350 Turbo w/shift kit 10" Redneck Performance Verter w/2500 stall Hooker Super Comps part#2808-1 Performer RPM Air-Gap 12 Bolt w/3:73 gears- Eaton Posi Comp Cams XE262 with 1.6 Crane Energizers, Road Demon 625 and Brodix IK 180 heads |
|
|
|
12-22-2007, 04:43 AM
|
#3 |
|
Senior Member
Join Date: Jun 2003
Location: Westminster, CO
Posts: 3,071
|
Re: For anyone interested, a link to my Powdercoat Oven build
Bought the 4" thick stuff.
__________________
Alex 1971 Lil' Red 350 SBC 700R4 |
|
|
|
12-22-2007, 09:13 AM
|
#4 |
|
Senior Member
 
Join Date: Jun 2007
Location: Pine Ridge Florida
Posts: 4,134
|
Re: For anyone interested, a link to my Powdercoat Oven build
What temp will you need?
|
|
|
|
12-22-2007, 11:23 AM
|
#5 |
|
Registered User
Join Date: Jan 2007
Location: Denver Colorado
Posts: 608
|
Re: For anyone interested, a link to my Powdercoat Oven build
When will you have this done? I might have to stop by i am starting to strip some stuff off the blazer for powdercoating. keep us updated! Looks good!
|
|
|
|
12-22-2007, 12:01 PM
|
#6 |
|
Senior Member
Join Date: Jun 2003
Location: Westminster, CO
Posts: 3,071
|
Re: For anyone interested, a link to my Powdercoat Oven build
temp ...depending on the powder you are using 400 degrees for 12 min. Should be all done within a few weeks or so.
__________________
Alex 1971 Lil' Red 350 SBC 700R4 Last edited by ChevyDude; 12-22-2007 at 12:02 PM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
