|
01-12-2008, 01:41 PM
|
#1 |
|
SWB 4X4 CLUB
Join Date: Feb 2005
Location: PA
Posts: 1,088
|
Heat stove question.
I am posting this here because it will get more views than the paint section.
I just scored a heat stove at the boneyard and had it blasted. What kind of paint should I use on it, so it wont blister off because of the heat? Is there a special primer or should I just use paint on the bare metal. Also, what years were the heat stoves used on? Jason |
|
|
|
01-12-2008, 02:21 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Heat stove question.
My suggestion would be to use POR's exhaust manifold paint without primer.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC Last edited by JimKshortstep4x4; 01-12-2008 at 02:21 PM. Reason: wording change |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
