Need template or picture for side AC vent cutting - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jayharrell · 03-13-2008, 07:58 PM

I'm putting factory AC in my non AC 69. I've got everything installed and ready to go, just need to cut the holes for the side vents and i can't find anything on where to put them to get the factory vents to mold to the dash right. Anyone have a picture with some reference or a template or something?? Seems i should be sure before i cut some hunks outa the dash.

I've tryed ventage air, but they just have a generic 2 1/2' hole, nothing relative to factory location.
Also called local junk yards thinking i could just trace one, but no luck here.

Thanks

sneakysnake · 03-13-2008, 08:48 PM

This will give you an idea of what you need.
http://67-72chevytrucks.com/vboard/s...85#post2012385

jayharrell · 03-13-2008, 09:53 PM

So if i print that pic on a whole page of paper it should work??

**john** · 03-13-2008, 10:53 PM

Quote:

Originally Posted by jayharrell

So if i print that pic on a whole page of paper it should work??

pm me your postal address and I will send you full size templates for the dash cutouts.

03-13-2008, 07:58 PM	#1
jayharrell Gettin By on Gettin By Join Date: Jan 2008 Location: Cedar Creek, Tx Posts: 1,033	Need template or picture for side AC vent cutting I'm putting factory AC in my non AC 69. I've got everything installed and ready to go, just need to cut the holes for the side vents and i can't find anything on where to put them to get the factory vents to mold to the dash right. Anyone have a picture with some reference or a template or something?? Seems i should be sure before i cut some hunks outa the dash. I've tryed ventage air, but they just have a generic 2 1/2' hole, nothing relative to factory location. Also called local junk yards thinking i could just trace one, but no luck here. Thanks Last edited by jayharrell; 03-13-2008 at 07:59 PM.

03-13-2008, 08:48 PM	#2
sneakysnake It's a catastrophic success. Join Date: Jan 2003 Location: Oklahoma Posts: 2,077	Re: Need template or picture for side AC vent cutting This will give you an idea of what you need. http://67-72chevytrucks.com/vboard/s...85#post2012385 Attached Images

03-13-2008, 09:53 PM	#3
jayharrell Gettin By on Gettin By Join Date: Jan 2008 Location: Cedar Creek, Tx Posts: 1,033	Re: Need template or picture for side AC vent cutting So if i print that pic on a whole page of paper it should work??

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.