![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Apr 2000
Location: Tarzana, CA
Posts: 78
|
Door inner panel replacement
I have inner panel and need to install it on passenger side door. Should I cut the door so that the inner panel slides up under some existing sheetmetal and weld as overlap? There is a lip on the replacement panel.
Thanks as always!
__________________
69 C10 lwb, 400 sb, Turbo 400, |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
![]()
I would weld it as you describe. You will want to seal the inner seam. I would be concerned that cutting the flange off to do a butt weld, could lead to warping.
Jim |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|