How to change tie rod ends on K10?? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

72K10 · 02-14-2003, 03:46 PM

Went to pull my tie rod ends, but can't because the long bar that the tie rod end is attached to hits the leaf spring before the tie rod end clears the hole. Anyone have advice?

72K10 · 02-14-2003, 06:02 PM

I figured it out and got both sides changed. Had to angle the tie rod ends and tap out and tap back in.

02-14-2003, 03:46 PM	#1
72K10 Registered User Join Date: Dec 1999 Location: New York Posts: 288	How to change tie rod ends on K10?? Went to pull my tie rod ends, but can't because the long bar that the tie rod end is attached to hits the leaf spring before the tie rod end clears the hole. Anyone have advice? __________________ RLTW 70C10 72K10 72K10 Cheyenne 72C10 Cheyenne Super

02-14-2003, 06:02 PM	#2
72K10 Registered User Join Date: Dec 1999 Location: New York Posts: 288	I figured it out and got both sides changed. Had to angle the tie rod ends and tap out and tap back in. __________________ RLTW 70C10 72K10 72K10 Cheyenne 72C10 Cheyenne Super

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.