![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
.....I am working on it.....
Join Date: Jul 2007
Location: Anaheim Hills, Ca
Posts: 960
|
Dana 44 knuckle question
I am looking for replacement knuckles for my '72 Blazer. The knuckles I sold have the numbers 35686 and 35687. What do these numbers represent? I need new knuckles, but the ones I am looking at have a different number number at 35663 and 35664, but look the same. Are they still the same? Thanks.
|
![]() |
![]() |
![]() |
#2 |
Senior Member
![]() Join Date: Mar 2003
Location: Colfax-California
Posts: 8,469
|
Re: Dana 44 knuckle question
Check the taper where the tie rod goes into the knuckle. Does it taper from the top or bottom? 1972 should be from the top
|
![]() |
![]() |
![]() |
#3 |
.....I am working on it.....
Join Date: Jul 2007
Location: Anaheim Hills, Ca
Posts: 960
|
Re: Dana 44 knuckle question
Yeah, its tappered from the top. Larger hole on the top side. I just want to make sure the difference in the casting numbers are still the same knuckle. I will be drilling the holes for a 3/4 bolt/heim anyway. Thanks.
|
![]() |
![]() |
![]() |
#5 |
Senior Member
![]() Join Date: Mar 2003
Location: Colfax-California
Posts: 8,469
|
Re: Dana 44 knuckle question
No difference that I can think of, unless the replacement is not of a flat top casting. Either way it should work just fine
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|