Lower A-arm install - The 1947 - Present Chevrolet & GMC Truck Message Board Network

pumpgas · 02-11-2009, 08:16 PM

How exactly do you know if/when you have these installed correctly? I have taken the entire frame apart am now putting it back together and have no real way to tell if the lower A-arm is installed correctly that I can tell. Any and all help on this would be great.

Kayotic · 02-11-2009, 08:29 PM

You asking about the stock arms?

The cross shaft should fit into a little pin.

pumpgas · 02-11-2009, 08:51 PM

Yes factory stock arms just installed new cross shafts in them and now need to reinstall them back onto the frame. I don't see really anything to locate them in a specific location.

Tx Firefighter · 02-11-2009, 09:04 PM

There is a recessed divot in the control arm shaft that will index on a nub sticking out of the crossmember.

pumpgas · 02-11-2009, 09:07 PM

Quote:

Originally Posted by Tx Firefighter

There is a recessed divot in the control arm shaft that will index on a nub sticking out of the crossmember.

Ok I thought that might be for something but didn't see the nub on the cross member I'll go look right now. Hope I put the cross shafts in correctly.

Ok after looking at my A-arms I installed one correct and one incorrect and they sit up in the cup and is held in place by the mounting bolt for the cup.

02-11-2009, 08:16 PM	#1
pumpgas Registered User Join Date: Dec 2008 Location: indiana Posts: 304	Lower A-arm install How exactly do you know if/when you have these installed correctly? I have taken the entire frame apart am now putting it back together and have no real way to tell if the lower A-arm is installed correctly that I can tell. Any and all help on this would be great. __________________ 00' Z28 ("wifes" car) 92' Mustang w/sbc everything needs a little heart beat 87' GMC Sierra Classic Short Bed Fleet side almost stock 69' Chevy short step carbed 6.0 w/400th trans. Completed w/325 miles on it

02-11-2009, 08:29 PM	#2
Kayotic Registered User Join Date: Mar 2008 Location: Lawrenceville, Ga Posts: 300	Re: Lower A-arm install You asking about the stock arms? The cross shaft should fit into a little pin. __________________ Atlanta Craigslist Hurst Indy Pickup Truck 3-Speed Shifter - 5010016

02-11-2009, 08:51 PM	#3
pumpgas Registered User Join Date: Dec 2008 Location: indiana Posts: 304	Re: Lower A-arm install Yes factory stock arms just installed new cross shafts in them and now need to reinstall them back onto the frame. I don't see really anything to locate them in a specific location. __________________ 00' Z28 ("wifes" car) 92' Mustang w/sbc everything needs a little heart beat 87' GMC Sierra Classic Short Bed Fleet side almost stock 69' Chevy short step carbed 6.0 w/400th trans. Completed w/325 miles on it

02-11-2009, 09:04 PM	#4
Tx Firefighter Watch out for your cornhole ! Join Date: Jun 2003 Location: Azle, Texas Posts: 14,162	Re: Lower A-arm install There is a recessed divot in the control arm shaft that will index on a nub sticking out of the crossmember. __________________ I'm on the Instagram- @Gearhead_Kevin

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.