|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-19-2009, 09:54 PM
|
#1 |
|
Seņor Member
Join Date: May 2002
Location: Edge of the world
Posts: 5,367
|
Idiot gauge bezel measurements, anyone?
If anyone has an idiot gauge bezel that they can take micrometer measurements off of, I'd greatly appreciate it. I'm looking for front opening measurements for the marked holes as well as rear opening measurements (the stock bezel has a bevel of about 3° on these holes).
__________________
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
