How would you fix this??? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

muckyp · 08-18-2009, 08:23 AM

What do ya'll think? Use one of those "door pillar patches" or just make a section out of sheet metal to complete the section broken off?

Bears63 · 08-18-2009, 08:25 AM

Personally I would look for a patch panel, but then my fabrication skills aren't the best. If you have the skills to fab up what you need, then go for it. At least then you know the quality of the repair piece intimately.

08-18-2009, 08:23 AM	#1
muckyp Registered User Join Date: Mar 2001 Location: Forney, Texas Posts: 290	How would you fix this??? What do ya'll think? Use one of those "door pillar patches" or just make a section out of sheet metal to complete the section broken off? Attached Images

08-18-2009, 08:25 AM	#2
Bears63 ...just another truck junkie.. Join Date: May 2009 Location: Watertown, SD Posts: 698	Re: How would you fix this??? Personally I would look for a patch panel, but then my fabrication skills aren't the best. If you have the skills to fab up what you need, then go for it. At least then you know the quality of the repair piece intimately. __________________ Mike "Bear" Shea

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.