|
09-13-2009, 06:45 PM
|
#1 |
|
laying low
 
Join Date: Mar 2001
Location: Searcy, Ark. USA
Posts: 13,310
|
metal bed floors
I recently read in a mag where a guy ordered a new factory steel bed floor for a 97 Chevy to use in his older truck instead of trying to straighten out his rusted, dented floor or trying to locate a better used one.
Has anyone considered doing this for these 67-72's. Could be a cheaper alternative to trying to find a good used one or a repop?
__________________
Boog 69 Chevy stepside, 358/T350, 4.11 posi, 4.5/4 drop, rallys, poboy driver primer is finer 91 Chevy sportside, Tahoe, Yukon & GMC Crewcab All GM..'nuff said. I stand for the flag and kneel at the cross |
|
|
|
09-13-2009, 07:02 PM
|
#2 |
|
I am a Referee of life.
Join Date: Jun 2000
Location: Greensboro N.C.
Posts: 13,993
|
Re: metal bed floors
Everything I've heard about the repops is good.I do know they are heavy enough to be good.I haven't used one or seen one installed(that I know of) so this is just from people mentioning what they felt.If you are doing your own bodywork then it might be worthwhile to do the later floor but it may cost a bundle to have a bodyman mate the two.
The repops are readily available here but I don't know about where you are.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion. You can't fix stupid,not even with duct tape. "My appearance is due to the fact that "GOD" does punish you for having too much fun!" Barrett-Jackson has perfected alchemy,they make rust into gold! "You can lead a horse to water but you can't saddle a duck" "Cleverly disguised as a 'Responsible Adult' "Sometimes your Knight in shining armor is just a retard in tinfoil" |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
