|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-19-2009, 01:50 AM
|
#1 |
|
Registered User
Join Date: Feb 2007
Location: Cali Central Coast
Posts: 5,191
|
source for carb linkage parts?
Anyone know where I can get the proper linkage for a quadrajet that has the kickdown for a TH400? The P.O. rigged this one up, but unless I'm not looking at it properly, it's got the wrong linkage on it, and the kickdown isn't engaging. (Or is the linkage improperly installed??) I've got another Q-jet to put on it (this one's pretty trashed) but I don't have the proper linkage. Any help would be greatly appreciated.
__________________
'67 SWB Fleetside ZZ4/350/Tremec 5-speed/4link/Scott's IFS - and fun as heck! SOLD  Click here to support the board Philippians 4: 6-7 |
|
|
|
11-19-2009, 01:56 AM
|
#2 |
|
Registered User
Join Date: Aug 2008
Location: simpsonville,sc
Posts: 417
|
Re: source for carb linkage parts?
Turbo 400 should have an electric kickdown switch at the gas pedal
|
|
|
|
|
11-19-2009, 11:08 AM
|
#3 |
|
Between Trucks...
Join Date: Mar 2002
Location: Los Angeles, CA.
Posts: 3,830
|
Re: source for carb linkage parts?
Some had the kickdown at the carb. Is that vacuum hose going to the booster? Looks like the throttle rod should be over the hose maybe. Are you getting WOT when the pedal is to the floor? You could take the easy way out and install the Lokar kickdown kit, or Edelbrock make a carb mounted micro switch.
__________________
Beat it to fit, Paint it to match... 
Last edited by Sinister; 11-19-2009 at 11:15 AM. |
|
|
|
|
11-19-2009, 08:30 PM
|
#4 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: source for carb linkage parts?
You may want to try this site.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
11-19-2009, 09:01 PM
|
#5 |
|
Senior Member
  
Join Date: Dec 1999
Location: Urbana,Ohio,USA
Posts: 4,618
|
Re: source for carb linkage parts?
71-72 were gas pedal mounted kickdown under the dash.
Up until then there were carb mounted. Looks like you are missing the tab that actuates the kickdown.
__________________
2008 Chevy HHR 1/2 panel. 1949 Chevy Panel truck(just sittin, waiting) Board member #6 Last edited by fine69; 11-19-2009 at 09:01 PM. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
