|
02-15-2010, 05:40 PM
|
#1 |
|
Senior Member
 
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,761
|
Tilt disassembly
I just wanted to say thanks to Krue and CUSTOM/10
All I wanted to do was replace my turn signal lever with the cruise/ turn signal lever. Well that and replacing the 4 speed bowl I got off of the classified section a while back. After I got it apart, I saw a crimped/bare wire in the harness...black/yellow tracer. Might have caused electrical problems down the road,dunno! Great write up down in the FAQ section, I had it figured out until I got to the pins, saw em, just didn't know they had to come out. Neat idea with the 8/32 screws as a puller. Very well illustrated, and easy to follow If anyone needs info., ya gotta check out the FAQ
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim Last edited by jaros44sr; 02-15-2010 at 05:41 PM. |
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
