Finally

[oldsmobilekindofguy]

I just picked up an NV4500 out of a 1992 chevy pickup and four aluminum rims that are mint off of about the same year gmc for my 67!!!!!!!!!!!!
I'm very excited to put it in i have been looking for quite awhile. I paid 500 for it all so i didn't think i did bad. what do you guys think

[Dingfodgy]

Good job on the tranny! Are you going to run the stock clutch setup or convert to hydraulic?
Now for the wheels- I don't think they're going to work on your '67. From what I've heard, late model alloys have alot of positive offset which can cause some rim to control arm interference in front. Also the center bore on the newer rims are too small for the drums on our trucks. You might have to run some spacers to accomodate these issues.

[oldsmobilekindofguy]

i converted to disc and was told they would work...i can resell them for more than i paid for them but i like them and they are six bolt cause thats what i need maybe someone can tell me if they will work or not on here

[oldsmobilekindofguy]

i'm not sure yet on the clutch i was tossing both ideas around