The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 10-08-2010, 05:19 PM   #1
blackbeaSSt
Registered User
 
Join Date: Sep 2010
Location: Anderson, SC
Posts: 325
uh oh. truck started getting the chugs and shakes after i turn it off

i've always seen peoples older cars/trucks do that. i don't wanna turn into "that guy" that people stare at all the time! could my ghetto carb setup be causing it?
blackbeaSSt is offline   Reply With Quote
Old 10-08-2010, 05:49 PM   #2
baclay9
Registered User
 
Join Date: Apr 2010
Location: Newcastle, OK
Posts: 1,344
Re: uh oh. truck started getting the chugs and shakes after i turn it off

My Dad's engine did that. I think it was because his timeing was advanced too much or something.
baclay9 is offline   Reply With Quote
Old 10-08-2010, 05:55 PM   #3
Sooner84
Registered User
 
Sooner84's Avatar
 
Join Date: Dec 2009
Location: Moore, Oklahoma
Posts: 379
Re: uh oh. truck started getting the chugs and shakes after i turn it off

My truck does this when its hot outside and its been running a while.
__________________
1984 chevy swb(1st truck, sold..)
2001 RCSB silverado, 5.3 with a little extra
2004 ECSB Silverado LT, 5.3 cam & bolt ons, 4l60e shift kit/stall, g80 & 3.73s

My first (1984 c10) Build
Sooner84 is offline   Reply With Quote
Old 10-08-2010, 06:19 PM   #4
irishman999
Registered User
 
irishman999's Avatar
 
Join Date: May 2010
Location: Reno Ne-VAH-da
Posts: 594
Re: uh oh. truck started getting the chugs and shakes after i turn it off

Your truck is dieseling, I saw your zip tie rigged carb and would probably start with your carb. Im not the brightest flash light but managed to rebuild my quadrajet and it only cost 25 bucks for the gasket kit. If you decide to rebuild it yourself do plenty of research online, I saw alot of how to video's on youtube.
irishman999 is offline   Reply With Quote
Old 10-08-2010, 06:21 PM   #5
C low
Registered User
 
C low's Avatar
 
Join Date: May 2010
Location: Albany Oregon
Posts: 71
Re: uh oh. truck started getting the chugs and shakes after i turn it off

its prob timing if it runs good just shut it of in drive that will kill the engine right away
C low is offline   Reply With Quote
Old 10-08-2010, 06:51 PM   #6
blazer2007
Registered User
 
Join Date: Jan 2007
Location: vernon b.c.
Posts: 3,022
Re: uh oh. truck started getting the chugs and shakes after i turn it off

I know my dist. was walking abit over time and I just reset the timing
blazer2007 is offline   Reply With Quote
Old 10-09-2010, 10:33 AM   #7
76/85 Truck
Registered User
 
76/85 Truck's Avatar
 
Join Date: Jun 2010
Location: Libby, MT
Posts: 163
Re: uh oh. truck started getting the chugs and shakes after i turn it off

My truck does the same thing. When fuel enters the cylinder, it becomes a vapor, and when your engine heats up (mine runs about 205-210 degrees) I think the hot cylinder walls ignite the fuel vapor, simply because vapor ignites better and quicker than liquid gasoline. And so when you shut the truck off, the pistons come to a stop and allows the fuel vapor that just got squirted in to sit for a split second, and it fires and drives the piston down. Anyone else think so? Just my .02
__________________
Rich



My first truck!! 1976 Chevy 3/4 ton Camper Special and a 1985 GMC body. Has a 350, 4 BBL Edelbrock, with a Turbo 350, and NP205 T-case.
76/85 Truck is offline   Reply With Quote
Old 10-09-2010, 10:38 AM   #8
nbpro
Account Suspended
 
Join Date: Dec 2008
Location: Huntsville,AL
Posts: 2,119
Re: uh oh. truck started getting the chugs and shakes after i turn it off

Quote:
Originally Posted by irishman999 View Post
Your truck is dieseling, I saw your zip tie rigged carb and would probably start with your carb. Im not the brightest flash light but managed to rebuild my quadrajet and it only cost 25 bucks for the gasket kit. If you decide to rebuild it yourself do plenty of research online, I saw alot of how to video's on youtube.
x2^^
nbpro is offline   Reply With Quote
Old 10-09-2010, 10:50 AM   #9
powerdriver 1958
Kid's Mechanic
 
powerdriver 1958's Avatar
 
Join Date: Nov 2006
Location: Kansas City
Posts: 8,241
Re: uh oh. truck started getting the chugs and shakes after i turn it off

Timing , sometimes idle speed too high. Vacuum advance not plumbed to a ported vac source............
powerdriver 1958 is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:46 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com