Door panel question. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

dcasalena · 04-28-2011, 10:10 AM

Will 67-70 steel door panels fit my '72 without changing window regulators or openers? same mounting hole allignment?

ls1nova71 · 04-28-2011, 10:37 AM

Yes, but they will stick out a little farther than the 67-71. Also there's no threaded holes for the bottom panel screws to go into.

dcasalena · 04-28-2011, 11:36 AM

Quote:

Originally Posted by ls1nova71

Yes, but they will stick out a little farther than the 67-71. Also there's no threaded holes for the bottom panel screws to go into.

Suggestions to get around the no threaded holes in the bottom? The top holes aren't threaded in the 72 door either right?

04-28-2011, 10:10 AM	#1
dcasalena Registered User Join Date: Jan 2011 Location: Acton, MA Posts: 220	Door panel question (67-71 steel in a 72?) Will 67-70 steel door panels fit my '72 without changing window regulators or openers? same mounting hole allignment? Last edited by dcasalena; 04-28-2011 at 10:34 AM.

04-28-2011, 10:37 AM	#2
ls1nova71 Registered User Join Date: Dec 2009 Location: Independence Mo Posts: 4,118	Re: Door panel question. Yes, but they will stick out a little farther than the 67-71. Also there's no threaded holes for the bottom panel screws to go into.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.