|
11-18-2011, 06:22 PM
|
#1 |
|
Registered User
Join Date: Jan 2007
Location: Canton, TX
Posts: 211
|
Fan Shroud Help....
The other day I thought I would romp on the old 350 just for the heck of it, so after that bright idea I hear the most awful sound. I pop my hood and notice that the fan shroud is pretty broke up on one side. It is still fastened properly and during normal even fairly heavy acceleration its fine. But when you floor it from a dead stop the fan blades get into the shroud. Any Ideas? Motor mount? Transmission mount? I am needing to replace mine. Are the aftermarket ones comparable to the original shrouds? Thanks in advance.
__________________
1969  Custom w/Turquoise Interior. 75k miles, 350 V8, THM400 (Almost) All Original 
|
|
|
|
11-18-2011, 06:52 PM
|
#2 |
|
Old Duffer
 
Join Date: Mar 2003
Location: Maine
Posts: 1,822
|
Re: Fan Shroud Help....
I'd check/ change all three mounts. It sounds like one is broken, and if it did it may have started a tear in the trans mount. If this is the case, the other engine mount may be borderline although it's generally in compression. Cheap insurance to replace all.
__________________
'68 Short C20 Flatbed Dually w/ 292 4bbl, Langdon cast headers, and WC T5 trans. '81 G10 Shorty Van "Good judgement comes from experience, and a lot of that comes from bad judgement." Will Rogers "Under promise, then over achieve." |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
