URGENT - Exhaust Gaskets - Help Please - The 1947 - Present Chevrolet & GMC Truck Message Board Network

*Zilverado* · 10-04-2003, 07:05 PM

So I'm putting some exhaust pieces back together and have some metal "felpro" gaskets (manifold flanged pipe connetions, etc.).

Should I use a HI temp sealant on these gaskets as well, or go just the gasket along - the flanges are good.

I have some "felt" gaskets as well for near the cat - these I usually use sealant on, but I'm not sure about the metal ones.

Help soon please.
Thanks

**68 Stepside** · 10-04-2003, 07:54 PM

I've never used hi-temp on metal flange gaskets. I've never had a leak either, but maybe I'm just lucky?

Good luck.

*Zilverado* · 10-04-2003, 08:00 PM

Thanks. That's what I kinda figured.

Actually, evening has come here, so I think I will leave the reassembly until tomorrow. So, I'm hoping that I will get a few more responses. I just want to make sure I do this right.

Thanks in advance.

10-04-2003, 07:05 PM	#1
Zilverado Account Suspended Join Date: Nov 2002 Location: Winnipeg, Manitoba, Canada Posts: 798	URGENT - Exhaust Gaskets - Help Please So I'm putting some exhaust pieces back together and have some metal "felpro" gaskets (manifold flanged pipe connetions, etc.). Should I use a HI temp sealant on these gaskets as well, or go just the gasket along - the flanges are good. I have some "felt" gaskets as well for near the cat - these I usually use sealant on, but I'm not sure about the metal ones. Help soon please. Thanks

10-04-2003, 07:54 PM	#2
68 Stepside huh? Join Date: May 2000 Location: Washington, Illinois Posts: 5,690	I've never used hi-temp on metal flange gaskets. I've never had a leak either, but maybe I'm just lucky? Good luck. __________________ Someday when I'm lonely, Wishing you weren't so far away, Then I will remember Things we said today. RIP El Jay

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-04-2003, 08:00 PM	#3
Zilverado Account Suspended Join Date: Nov 2002 Location: Winnipeg, Manitoba, Canada Posts: 798	Thanks. That's what I kinda figured. Actually, evening has come here, so I think I will leave the reassembly until tomorrow. So, I'm hoping that I will get a few more responses. I just want to make sure I do this right. Thanks in advance.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.