![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Account Suspended
![]() Join Date: Jun 2003
Location: PA
Posts: 1,411
|
![]()
Looking for a good front driveshaft that would be 28.5" long with the slip-joint in the middle of it's travel. This would be the center of U-joint cap to center of farthest U-joint cap. Probably would be 27" fully compressed and 30" fully extended.
Needs to fit a NP205 transfer case with a yoke and the double cardan joint at that end, and a Dana 44 yoke other end. I have one that's been totally rebuilt that's 28.5" fully compressed, and 31.5" fully extended. Just put a lot of money into it, all parts replaced and balanced, like new condition, will trade for value. Thanks. 72longbed |
![]() |
![]() |
![]() |
#2 |
Account Suspended
![]() Join Date: Sep 2010
Location: centre al
Posts: 2,472
|
Re: WTB Front Driveshaft for 72 K20 ....
I got one that's short I will check the length. I m getting out of the 4 wheel drive stuff.
|
![]() |
![]() |
![]() |
#3 |
Account Suspended
![]() Join Date: Jun 2003
Location: PA
Posts: 1,411
|
Re: WTB Front Driveshaft for 72 K20 ....
Sounds good ... pics too if you would please.
Thanks. 72 |
![]() |
![]() |
![]() |
#4 |
Account Suspended
![]() Join Date: Sep 2010
Location: centre al
Posts: 2,472
|
Re: WTB Front Driveshaft for 72 K20 ....
Sure will. Prob be tomorrow sometime. May can run outside shortly will get pic asap.thanks.
|
![]() |
![]() |
![]() |
#5 |
Account Suspended
![]() Join Date: Sep 2010
Location: centre al
Posts: 2,472
|
Re: WTB Front Driveshaft for 72 K20 ....
Will upload pics but mine is 25 collapsed. And around 27.5 mid way.will upload pics in a few.
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|