![]() |
![]() |
#1 |
Registered User
Join Date: Oct 2003
Location: San Jose Ca.
Posts: 3,335
|
![]()
The previous owner gave me a set of flowtech headers (not shorties) with the truck. Not the top of the line but since I have a exhaust manifold crack that is growing they will do the job. The question I have is this. When In installing the headers do you have the exhaust pipe go all the way into the header or do you have to cut it?
I have never installed headers before so I have no idea what I need to do. Thanks in advance. ![]() |
![]() |
![]() |
![]() |
#2 |
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Cut off pipe right at the header, and get a collector flange welded on.
A muffler shop should be able to connect your pipes to your headers for minimal cash, and it'll last longer and be way better than clamps and stuff. |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Oct 2003
Location: San Jose Ca.
Posts: 3,335
|
The headers come with the flanges. Maybe time to ask my bro n law to come down and bring his welder.
thanks longhorn man. once again ![]() |
![]() |
![]() |
![]() |
#4 |
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
If you install the dead soft alluminum gaskets, you'll never have to replace them again...the paper junk (probably what came with them) will blow out in a couple weeks.
And if I say spend the money...it is most likely money well spent being I am so cheap. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|